Toyota Trucks

July 30, 2010

Mass Air Flow Sensor 22RE ??

Filed under: Uncategorized — admin @ 1:43 am

I think I messed up my MAFS while messing with it.  The flap under it wasn’t
closing properly making the engine run rich & rough.  Now it won’t start or
spark at the coil

Question:

Under the silicone sealed plastic lid, I used WD-40 to loosen the shaft the
flap pivots on.  I am wondering if I could have damaged the circuitry.

Perhaps I may have reconnected the three wires incorrectly.  Yeah I should
have labeled them

Actually if there were mis-attached it’d be the two on the right side as the
left one was obvious.  Any diagrams or clues as to how it is wired under
there?

 TIA

Jim

No Comments »

No comments yet.

RSS feed for comments on this post. TrackBack URL

Leave a comment

You must be logged in to post a comment.

Powered by WordPress